Roll Cages FAQ Information
Key Features - FAQ  Cross Members: Key Features - FAQ
|
When you choose mild steel tubing it is either 1 3/4" or 1 5/8" outside diameter X .134 wall HREW (hot rolled electric weld) material. 1 3/4" tubing for a roll bar and 1 5/8" tubing for a roll cage. If...
|
|
|
In most cases we can bend the tubes that run from the top of the main hoop down through the package tray area rather than straight down to the floor. This will allow you to retain your rear seat. There is an additional charge...
|
|
|
There are a couple of things to take into consideration, in order to answer this question completely. Sometimes the racing sanctioning bodies rules (NHRA, IHRA, NMCA, etc) dictate the use of 4130 tubing. (Please check the...
|
|
|
We can bend the tubing to bend down in front of the dash, to allow you to keep the stock dash in most cases. In some smaller cars, such as the Corvette it is best to remove the stock dash and bend the tubes to follow the...
|
|
|
In most cases, we do not charge a custom design fee. With more than 200 different designs already cataloged chances are we have what you need.
|
|
|
|
